This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
English
Deutsch
Hello There, Guest! Login Register


Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Title: Vernier compatibility


#1
Hello Guys,

On Harold Hall's interesting website I found this digital vernier mounted on a lathe. The vernier has a big LCD display so that it is used as a digital readout by itself. I would like to know if this kind of verniers are compatible with the Caliper2PC interface.

Does anybody know which protocol it uses?
 
Reply
#2
Hi Besnik,

We will have to check if this type of caliper has a data port at all. I am not sure it has.

[Image: LrgMHdMods01.jpg]

Does anybody know?
 
Reply
#3
According to pictures of this type of caliper there seems to be no opening for a data port. However some calipers have a data port with soldering terminals on the PCB even if there is no opening it the plastic housing (see picture).

[Image: B1Kabel.jpg]

To find out, one have to disassemble the caliper and take a look at the PCB.
 
Reply
  


Forum Jump:


Browsing: 2 Guest(s)