This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
English
Deutsch
Hello There, Guest! Login Register


Thread Rating:
  • 1 Vote(s) - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Title: Achsenzählrichtung umkehren


#1
Hallo Forum,

An der X-Achse meiner Fräse würde ich gerne die Zählrichtung der Achse umkehren. D.h. wenn ich den Tisch nach rechts bewege soll der angezeigte Messwert abnehmen. Momentan wird der angezeigte Wert beim Bewegen des Tisches nach rechts erhöht.
 
Reply
#2
Mit einem Doppelklick auf die Digitalanzeige deiner X-Achse klicken, sodaß sich das Bedienfeld öffnet. Durch das Doppelklicken wird im Bedienfeld automatisch der Kanal deiner Achse ausgewählt. Danach kannst du mit der Schaltfläche "Auf / Ab" die Zählrichtung für deine Achse umkehren.


Attached Files Image(s)
   
 
Reply
  


Forum Jump:


Browsing: 1 Guest(s)