This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
English
Deutsch
Hello There, Guest! Login Register


Thread Rating:
  • 1 Vote(s) - 4 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Title: Lathe Setup


#1
Greetings Everyone and Thank You Tomer for accepting me to this Forum! I have had my Caliper2PC for almost 10 years but have only used it a few times and recently I have a lathe project inwhich I need its Lathe DRO. Well long story short all the Ports work fine 1-6 and I can plug into them and see that my scales read fine. I only have 2 scales on my lathe X and Y, I have not installed one on the Angle slide yet which is fine for now. I can get Z to read on the Lathe DRO screen fine just not the X axis even when I select what Port it is on, sometimes it conflicts with the cross slide also. Any help in the settings would be appreciated. It worked fine before but that was well a long time ago and I forgot how to do it. Thanks in advance for any help!
 
Reply
  


Messages In This Thread
Lathe Setup - by Matthew - 04-22-2021, 08:39 PM
RE: Lathe Setup - by Jack - 04-24-2021, 05:52 PM
RE: Lathe Setup - by Tomer - 05-02-2021, 09:08 AM
RE: Lathe Setup - by Matthew - 05-04-2021, 09:46 PM
RE: Lathe Setup - by Matthew - 05-06-2021, 09:23 PM
RE: Lathe Setup - by Tomer - 05-09-2021, 11:23 AM
RE: Lathe Setup - by Matthew - 05-13-2021, 11:22 PM
RE: Lathe Setup - by Tomer - 05-14-2021, 05:23 AM
RE: Lathe Setup - by Matthew - 05-14-2021, 09:05 PM

Forum Jump:


Browsing: 1 Guest(s)