Search Results
|
Post |
Author |
Forum |
Replies |
Views |
Posted
[asc]
|
|
|
Thread: Vernier compatibility
Post: RE: Vernier compatibility
Hi Besnik,
We will have to check if this type of caliper has a data port at all. I am not sure it has.
http://www.homews.co.uk/LrgMHdMods01.jpg
Does anybody know? |
|
Ben |
Hardware
|
2 |
310,386 |
04-15-2019, 12:19 PM |
|
|
Thread: Save settings
Post: RE: Save settings
All settings and variables as well as DRO windows positions can be saved in a settings file ("File"->"Save Settings"). Save the file on the desktop so that it is easily accessible. A *.c2p file will b... |
|
Ben |
Software
|
1 |
36,382 |
04-02-2019, 06:32 AM |
|
|
Thread: Using Caliper2PC DRO to turn on my lathe's engine
Post: RE: Using Caliper2PC DRO to turn on my lathe's eng...
Lorenzo Wrote: (03-20-2019, 10:36 AM)
--
Why are there 3 connectors GND, IN and Vcc on the relais card? :huh:
--
The relais PCBs with optocoupler use the optocoupler as a switch. The Caliper2PC I/O... |
|
Ben |
Hardware
|
4 |
94,279 |
03-24-2019, 10:02 AM |
|
|
Thread: Using Caliper2PC DRO to turn on my lathe's engine
Post: RE: Using Caliper2PC DRO to turn on my lathe's eng...
The output ports of the Caliper2PC interface have 5V levels (0V = low, 5V = high). A relais with optocoupler that works on 5V can be used to switch your motors.
These relais cards can be found on ... |
|
Ben |
Hardware
|
4 |
94,279 |
03-17-2019, 07:50 AM |
|
|
Thread: Interface not recognized in the software
Post: RE: Interface not recognized in the software
Thank you Jack, that did the trick. |
|
Ben |
Software
|
2 |
37,978 |
03-07-2019, 08:20 AM |
|
|
Thread: Interface not recognized in the software
Post: Interface not recognized in the software
I have installed the Caliper2PC software on my PC and connected the interface to the USB port. The interface is not recognized in the software. The USB bullet shows red.
Any help appreciated. |
|
Ben |
Software
|
2 |
37,978 |
03-06-2019, 07:34 AM |